PowerVerter APS Inverter/Charger with Auto-Transfer Switching
Tripp Lite APS1250. Input voltage: 12 V, Output power: 2500 W, Output voltage: 120 V. Product colour: Black. Width: 222.2 mm, Depth: 228.6 mm, Height: 177.8 mm. Package width: 269.2 mm, Package depth: 259.1 mm, Package height: 320 mm. Master (outer) case width: 269.2 mm, Master (outer) case length: 259.1 mm, Master (outer) case height: 320 mm
- APS1250 serves as an automotive or stationary DC-to-AC inverter with automatic line-to-battery transfer and integrated battery charger. - Supports 120V AC output from a 120V AC line power source or 12V DC battery source. - 16.6 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for equipment compatible with a one cycle transfer time. - 1250 watts continuous AC output in inverter mode, 1440 watts continuous AC output in AC mode. - Double Boost™ inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds. - OverPower™ inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions (For best results, utilize OverPower usage for as short of a duration as possible, ensure battery bank and cabling is able to provide full nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage). - 3 stage, 30 amp battery charger with adjustable settings for wet/gel battery types offers fast, reliable battery recharging. - Protected hardwire bolt-down input lugs safely accept heavy gauge input wiring from attached battery bank. - Two built-in NEMA 5-15R output receptacles pass 120V line power or inverter output through to connected equipment. - Reliability enhanced large-transformer design with secure mounting flanges and protected DC wiring terminals. - Moisture-resistant construction enables vehicular or marine operation in high humidity environments. - 3 position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings. - Set of six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status. - Set of 4 configuration dipswitches support wet/gel battery charging profiles, adjustable 135/145V high voltage auto transfer during overvoltages and selectable 75/85/95/105V AC low voltage auto transfer during brownouts. - Resettable 8A charger AC input breaker and resettable 12A AC output breaker and automatic 2 speed cooling fan protect the inverter from load and temperature related failures. - Grounding lug properly connects the inverter/charger system to earth ground or vehicle grounding system. - Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop. - Front panel remote control connector enables remote off/on switching (requires APSRM4 switch accessory). Optional APSRM4 accessory also includes user configurable jacks to support inverter shutoff or startup as a vehicle ignition is engaged.
